It is possible to send input image data to SceneScan through the API. If you press "reset calibration" in the web interface, SceneScan will forget it's calibration and process the input image data without rectification. Please be aware that when streaming input data through the network, th...

You need to press the button for 3 seconds right from the moment when you plug in the power cable. Otherwise it will not have an effect.

It is technically not possible to have a communication with the device if you don't have a correct IP address configuration, so there cannot be a GUI for that.

If the reset was successful, then the busy light will be flashing even without cameras connected, as in the default configuration it will be playing the hard-coded default sequence. If it is not flashing, then the reset was not successful and it is still at the old IP. Please consult the manual abou...

Hi Eren, Is your computer in the same subnet (that is 160.69.69.x). Actually 160.x.x.x is a very unusual address range. Your computer might route this to the internet. I would recommend that you update to the latest firmware. The current firmware supports DHCP server and client. This way you can lea...

This looks like Jumbo frames are not enabled or working on your host PC. Can you try disabling jumbo frames in SceneScan's network settings? If NVCom works after this, then please check the settings of your network adapter. The configured MTU size should match the MTU size of SceneScan's settings (t...

I couldn't find an obvious problem with your configuration. According to the logs the system was running for at least 3 hours at at the configured 10 fps. Did you make sure that all browser windows that stream video data (preview, calibration, review calibration) were closed when you tested NVCom? T...

Hi Peter,

could you send the device configuration (downloadable from the web-interface maintenance page) to service@nerian.com? I will investigate the issue.

Hi Matti, subpixel optimization tries to improve the accuracy of the image correlation to an accuracy that is below 1 pixel (we compute with 1/16th pixel). This is a separate step after it found the initial correlation at pixel level accuracy. This method significantly improves the the depth resolut...

Hi Matti,

which firmware version is running on your SceneScan device and which NVCom version do you have installed on your PC?

Regards,
Konstantin

Hi Sri, as I said, the network throughput is actually the limiting factor in case of color cameras. In through-put mode there is actually more data to be transmitted as you have two color images instead of only one color image and a disparity map. You will have to reduce your image resolution. Regar...